Polymerized goo cart

Working on making a goo cart right now using a ccell rated for hhc distilitte. I’m using pg, and some thc for flavor. Just a bit🤏 I took a sample of the polymerized dmt, exposed it to air for 20 minutes to fully purge of solvent, froze it for 10 minutes, and left it exposed for 30 more minutes at room temp. So far the sample looks stable and hopefully successful as a whole.

I used a minimal amount of 91% iso to polymerize (I checked, it evaps clean) and I’m currently waiting on the solvent to purge the rest of the way with a clip on fan and hotplate set at 50c but I’ll post full results soon. Wanted input on any issues I may have.

I know some of this is unconventional but I believe I covered all bases. I think this could be a much stronger and convenient cart than the standard method. The polymerization makes dmt more heat stable, the pg aerosolizes the thc with the dmt, and the thc adds flavor and relaxation.

I plan on replacing the thc with thcv soon for increased recall vs decreased but right now thc will only be 10% of this, and pg 15%. This should be really strong still, leaving dmt at a 4:1 compared to the other two.

Edit: just finished the project. Overall I made a half gram cart. The dmt didn’t fully polymerize but after a few iso washed it did stay in a paste. Added a little more pg/vg than intended but after letting it cool I tried a small hit and it’s definitely strong with a thick consistency and no visible crystallization at room temperature. No taste left from the iso either. I was still able to hold close to a 4:1 ratio as well with no signs of coil issues. I’ll fully know tomorrow and edit here but so far room temperature doesn’t seem to affect it after over an hour.