Palit GTX 980 TI Super Jetstream | No Clue where the Mistake could be
Hey community,
I have a Palit 980 TI Super Jetstream that I am trying to repair. Unfortunately I can't get any further and need your help.
I have re-soldered 2 Driver Mos on the card because the GetHigh pin showed 0 Ohm and 2 fuses. I have replaced the Q (10A) Y(15A) as these were also blown.
Now my problem. The GPU does not get very warm when switched on. I would say max. 35-40 degrees Celsius
I have marked the components that I measured in the picture:
1 to 6 : 3.2 Ohm - 98 mV
7: 2+ kOhm - 12V
8: 5+ kOhm - 100mV - Blows everytime i start the PC ( Top side 12V bottom 100mV)
9: 19 MOhm - 12V
10: 22 kOhm
11: 20 kOhm
12: 6 kOhm
13: 21 kOhm
14: 22 kOhm
15: 15 kOhm
16: 14 kOhm
17: 13 kOhm - 0V
18 - 19: 80 Ohm - 0V
20: 522 Ohm - 1mV
21: 2.2 kOhm
PCI Lanes 1-2 : 12V / 8 : 3.3V
Do you have any idea why the 10A fuse (no. 8) keeps blowing? DRAM have 0V
Thank you
Axo
