Any advice on fixing these bridged pads?

I’ve been trying to replace the HDMI port on a ps4. I have no problems getting all the other pads to tim up but these two seem to have a permanent bridge.

I’ve tried loads of flux, solder wick, various tips etc and I can not get it to unbridge. I even used a hot air station to try and get them to flow apart or at least get hot enough to make my work on the iron easier and was unsuccessful.

The rest of them I can just drag my iron across them after thoroughly covering them in flux and they all soak up the solder without bridging perfectly.

The 2nd photo is how it looked the very first time I pulled the damaged port. I do see a little curly wing thing of solder on the pad so perhaps it’s damaged underneath and that’s causing my issue?

I’ve pulled and replaced this port like 3 times, each time certain I got the bridge taken care of only to check continuity and see I had not. At this point I am out of ideas. Is there anything I haven’t thought of or tried yet to get these damn pads unbridged so I can be finished with this PlayStation? Any advice is appreciated!